Tired of unwanted engine movement under load and drivetrain slop when shifting? 034Motorsport's Density Line Motor Mounts for the B6/B7 Audi S4 & RS4 are designed to provide improved performance over the factory mounts, as well as eliminate the failure-prone "Active Engine Mount" feature.
By replacing the voids and fluid cavities in the factory mounts with high-quality Density Line rubber, and manufacturing the mount bases from steel instead of aluminum, these mounts drastically reduce unwanted engine movement and eliminate most common failures of the factory mounts.
STREET DENSITY Mounts are solid rubber mounts with a 50 durometer about 10% stiffer than stock, this means they still ride smooth and quiet but provide a marked improvement in drivetrain dampening over stock mounts. Livable street performance with serious sport intentions. Note, since there are no voids or air pockets in these mounts, even though the rubber is only 10% stiffer, the resulting reduction in drivetrain movement is actually 25% stiffer.
THIS IS NOT AN OE MOUNT, OR AN RS4 MOUNT, AND THESE ARE NOT AVAILABLE FROM ANY OTHER SOURCE - These are built by an OE supplier to 034Motorsport specifications for performance applications.
Combine with Density transmission mount and 034Motorsport snub mount and cage for the ultimate in performance drivetrain mounting.
Please Note: These Active Motor Mount Resistor Bypasses are designed keep the check engine light off on vehicles equipped with Active Engine Mounts from the factory. Simply plug these in to the factory harness and go!
Please Note: The nuts for these mounts should be torqued to the factory specification of 25 Nm (approximately 18.5 ft. lbs.). Overtightening these nuts can cause damage to the mount!