The APR Oil Catch Can System is designed to prevent excessive crankcase oil vapors from entering the intake system while the engine is under boost. In doing so, the system helps reduce oil pooling in the intercooler hoses, carbon buildup on intake valves, and the decrease in octane caused by oil vapors.
APR’s Oil Catch Can system installs between the PCV’s outlet and the inlet to the intake system and is designed to catch unseparated oil vapor. The supplied bracket and scratch resistant gasket allow the system to be installed on the required APR Carbon Fiber Intake System. This enables compatibility with all applicable MQB platform 1.8T/2.0T engines. The supplied hoses then connect and route out of site, for a clean and attractive install.
Unlike many catch can designs on the market, the APR system utilizes a track-proven four-staged baffling system. The baffles cause oil to pool at the bottom of the can, rather than the intercooler hoses. APR’s brutal track testing has proven the system works as designed, catching oil in the can and leaving the return hose clean to the touch!
Removing the oil is a cinch! No tools or can removal/disassembly are required thanks to a quick drain valve and hose conveniently located at the bottom of the can. Furthermore, servicing the can is simple, thanks to the billet two piece design.
Requirements: The APR Oil Catch Can system requires an APR Carbon Fiber Intake System for install.
NOTE: Despite the popularity of deleting it, APR's Oil Catch Can retains the factory PCV. Pulling vacuum on the crankcase is ideal as it helps ensure that all necessary gases escape. However, the factory unit incorporates a check valve that sees boost pressure. If that valve fails a boost leak would occur, decreasing engine performance until the valve was replaced. To date, APR has not seen a PCV check valve failure on any Gen 3 TSI engine. With the factory valve in place, it is also possible that some oil enters the intake tract through the cylinder head. However, most goes the way of the catch can and is subsequently captured. Though APR has had positive results retaining the factory PCV, the desire to replace it is understood and APR will be releasing a factory PCV delete that connects flawlessly to our catch can.